Audi Volkswagen ODIS 6.2 with license

How to set up VAS 6154 wifi

Step 1: Input the fourth CD and open it and then install the vas 6154 driver

Step 2: Open the CD and then chose the vas 6154 driver to install

Step 3: After installed and click on the Desktop – symbol

Step 4: Click on the Device Configuration

Step 5: Choose the connection way “WLAN”

Step 6: Choose the “save”

Step 7: Plug the vas 6154 to the car

Step 8: Open the WIFI and find the VAS-6154 wifi name and connect it.

Step 9: It shows Connected

Step 10: The state of connect successfully

Step 11: Open odis software. Now the latest version is 4.4.1

Step 12: VAS 6054 wifi connection setup successfully.

Done! Ready for use!

 Component Unlocking with ODIS on VWAudi

Volkswagen & Audi introduced component lock (anti-theft/immobilizer) function to their newer transmission control modules to help fighting unauthorized swap of the control unit. If a TCU/TCM is faulty and has been replaced, a component unlock is therefore required.

Note: You don’t need to unlock the unit if you choose to clone the SW from your original unit to the new one.

Typical error messages:

Contains Component protection (Component protection active)
The control unit is currently associated with a VIN other than the vehicle VIN or the control unit VIN

You need the following tools to perform component unlock:

VAG diagnosis tool (like VAS5054A, VAS 6154) to connect to your vehicle
ODIS software
A VW/Audi account depending on the vehicle

Procedure for unlocking TCU:

Run a diagnosis in your ODIS software
Locate and select the entry “Component protection”
Click on “Perform test…”
Click on “Done/Continue”
Enter the required information. (Activation number can be your own record number)
Enter your VW/Audi online account credentials
Click on “OK”
On success, ODIS should display “The component protection base programming has been carried out successfully.”
Click on “Done”
Follow the instructions provided by ODIS
End of your component base programming
Go back to the test screen and you should see a green check mark before component protection
Perform basic settings using guided functions
Erase your previous fault codes
You may now load your SW into the TCU if needed. If you don’t have the flash program, you may contact your Shing Hoi representative.